Filter
Top Products
TH-II serIes • InsTallaTIon/operaTIon/servIce manual - pg. 12
OPERATING INSTRUCTIONS
I
o
I
o
Up/Down
Arrow Keys
Temperature
Display Button
Time Key
Holding
Indicator Light
Cooking
Indicator Light
On/Off
Power Switch
Hold Knob
Cook Knob
Digital
Display
Heat
Indicator Light
1. Push power switch to ON (I) position.
Control will display 0°F or 0°C.
2. Set the holding temperature.
• Rotate the hold knob to the desired holding
temperature. The set temperature will appear
in the Digital Display
140
.
F
and the
temperature display button will illuminate.
• The holding indicator light will illuminate
while in hold mode.
• Holding temperature range:
60° to 205°F (16 to 96°C)
3. Set the cooking temperature.
• Rotate the cook knob to the desired
temperature. The set temperature will appear
in the Digital Display
250
.
F
and the
temperature display button will illuminate.
• The cooking indicator light will illuminate
while in cook mode.
• Cooking temperature range:
200° to 325°F (94 to 160°C)
• Note: Cooking mode not active unless timer
is running.
4. Set timer.
• Press Up or Down arrows when cook knob is
set to begin cooking.
• Press Up or Down arrows to adjust the
time while cooking.
• Note: Hold timer button for 3 seconds
when in cook mode to cancel timer (display
shows
----
).
5. PREHEAT oven for 30 minutes before
loading food. The heat indicator light will
illuminate and will remain lit as long as the oven
is calling for heat.
6. Load the oven with food and adjust cooking
timer as needed.
Notes:
• When the oven temperature reaches the set
temperature, the heat indicator light will turn off.
• Press and hold the Temperature Display Button
for 3 seconds at any time to display the Actual
oven temperature
190
.
F
.
To toggle between fahrenheit (°F) and celsius (°C):
Press the Temperature Display Button at any time to
display the alternate temperature.
The factory default is Fahrenheit. To change to Celsius:
1. Press and hold the Temperature Display Button
and the Down Arrow Key for 5 seconds.
2. The control will show
.
C
for 3 seconds to verify
selection and then show the temperature in ºC.
3. Repeat to toggle to Fahrenheit.
Note: With a power failure, factory test, etc., the control
will retain the ºC or ºF setting selected by the user when
power is restored.