Filter
Top Products
ASC-4G Gas Convection Oven - Electronic Control • 3
INSTALLATION
DANGER
IMPROPER INSTALLATION,
ALTERATION, ADJUSTMENT,
SERVICE, OR MAINTENANCE COULD
RESULT IN SEVERE INJURY, DEATH,
OR CAUSE PROPERTY DAMAGE.
READ THE INSTALLATION,
OPERATING AND MAINTENANCE
INSTRUCTIONS THOROUGHLY
BEFORE INSTALLING OR SERVICING
THIS EQUIPMENT.
CAUTION
DO NOT LIFT OR MOVE THE
OVEN BY USING THE DOORS
OR THE DOOR HANDLES.
CAUTION
METAL PARTS OF THIS EQUIPMENT
BECOME EXTREMELY HOT WHEN
IN OPERATION. TO AVOID BURNS,
ALWAYS USE HAND PROTECTION
WHEN OPERATING THIS APPLIANCE.
DANGER
DO NOT store or use gasoline or other
fl ammable vapors or liquids in the
vicinity of this or any other appliance.
The Alto-Shaam convection
oven must be installed in
a location that will permit
the oven to function for its
intended purpose and to
allow adequate clearance for
ventilation, proper cleaning,
and maintenance.
1. Hood installation is required.
(CHECK LOCAL CODES.)
2. The oven must be installed on a stable and
level surface. A non-combustible, heat
resistant, and fireproof surface is highly
recommended. If the oven is to be installed
on a combustible surface, factory supplied
legs or oven stand MUST be used.
3. DO NOT install this oven in any area where
it may be affected by any adverse conditions
such as steam, grease, dripping water, high
temperatures, etc.
4. This appliance must be kept free and clear of
any combustible materials.
5. This appliance must be kept free and clear
of any obstructions blocking access for
maintenance or service.
®
SITE INSTALLATION
WEIGHT
NET
420 lb (191 kg)
SHIPPING
465 lb (211 kg)
CRATE 45" L X 53" W X 49" H
DIMENSIONS:
(1143mm x 1346mm x 1245mm)
MINIMUM ENTRY CLEARANCE
31-1/2" (800mm
) UNCRATED
DIMENSIONS H x W x D:
EXTERIOR
: 58-1/2" x 38" x 44-1/2"
(1486mm x 964mm x 1130mm)
INTERIOR
: 24" x 29-1/8" x 25"
(610mm x 740mm x 635mm)
MINIMUM CLEARANCE REQUIREMENTS
COMBUSTIBLE
SURFACES
NON
-COMBUSTIBLE
SURFACES
BACK
0" (0mm) 0" ( 0mm)
LEFT SIDE
2" (51mm) 0" ( 0mm)
RIGHT SIDE
2" (51mm) 2" (51mm)
FROM GREASE
PRODUCING EQUIPMENT
6" (152mm) 6" (152mm)
ENTRY CLEARANCE:
31-1/2" (800mm)
UNCRATED
RECOMMENDED
SERVICE
ACCESS:
20" (508mm)
RIGHT CONTROL SIDE