COMBITOUCH® ES SERIES • ELECTRIC INSTALLATION MANUAL • 26.
INSTALLATION
WATER CONNECTIONS
WATER SUPPLY & INSTALLATION
WATER REQUIREMENTS
TWO (2) COLD WATER INLETS - DRINKING QUALITY
ONE (1) TREATED WATER INLET: 3/4" NPT*
ONE (1) UNTREATED WATER INLET: 3/4" NPT*
LINE PRESSURE: 30 to 90 psi
2.8 to 6.2 bar
* Can manifold off of one 3/4" line
REFER TO PUBLISHED SPECIFIC WATER REQUIREMENTS
WATER DRAIN: 1-1/2" CONNECTION WITH AIR GAP
Flush the water line at the installation site.
Install water intake filters (provided) [see Figure 1]
before connecting the oven to the water supply.
A hose connector is supplied for flexible hose
connection to the COLD water source.
Backflow Prevention — The equipment must be
installed with adequate backflow protection to
comply with applicable federal, state, and local
codes.
PIPE SEALING TAPE (
TEFLON®) MUST BE USED
AT ALL CONNECTION POINTS. The use of a pipe
sealing compound is not recommended.
Incoming cold
water connection
T connection
Cold water line
to untreated
oven connection
Cold water
line to filter
or treatment
system
Water Filter
Install water
intake filters
Figure 1
ONE SUGGESTED
METHOD OF INSTALLATION
NOTE:
BOTH TREATED AND UNTREATED
WATER CONNECTIONS MUST
BE CONNECTED FOR PROPER
OPERATION OF THE OVEN.
BOTH CONNECTIONS CAN BE
TREATED WATER, BUT SHOULD
NEVER BE CONNECTED TO ONLY
UNTREATED WATER.
UNIONS OR FLEXIBLE LINES
SHOULD BE USED TO ALLOW FOR
OVEN MOVEMENT WHEN BEING
SERVICED OR CLEANING
IS NEEDED.
CombiGuard™
FI-23014 shown
Alto-Shaam now offers an improved water
filtration system for Combitherm
®
. The
CombiGuard™ 10 & 20 triple-guard water
filtration system filters dirt, sediment, and other
debris as small as 1/2 micron. This system also significantly reduces
chlorine content to protect against corrosive chorine compounds.
CombiGuard improves equipment efficiency, reduces service requirements
and extends the life of the Combi oven. After installation, confirm that
water quality standards specified in this manual are being met. Filtration
systems include one filter cartridge. Additional cartridges can be purchased
separately. Refer to an earlier page for additional ordering information.
The CombiGuard™ BWS Blended Water System utilizes reverse osmosis to
remove more than 97% of the total dissolved solids from water which can be
precisely blended with filtered and treated water.
Treated cold water
to backflow preventer
to treated connection
on oven