Filter
Top Products
QUICKCHILLER • MN-29647 (REV. 0) • INSTALLATION/OPERATION/SERVICE MANUAL • 4.
INSTALLATION REQUIREMENTS
The model QC2-3 is a counter mounted unit and
must use legs that allow for a 4" (102mm)
clearance between the cabinet and the counter.
For all other
models, install
the appliance
on a smooth and
level floor surface. Use the adjustable
cabinet legs to level the Quickchiller.
Adjust from front-to-back and from side-to-side
with the use of a spirit level to evenly distribute
the cabinet weight and avoid pulling the cabinet
alignment out of square.
After leveling the cabinet, check that the door
handle is aligned properly. Also check the height
relationship of the optional roll-in cart to the
cabinet. Adjust the Quickchiller height as needed
to accommodate the cart and to securely close the
Quickchiller door.
DOOR SEAL:
Check the door gasket to make certain it is sealing
properly and that the gasket provides an even and
positive seal around the entire door frame.
GUIDE INSTALLATION FOR TROLLEY
OPTION ON QC2-100 & QC2-100/REMOTE
Trolley Guide Installation
1. Align each guide rail with the holes located
under the cabinet.
2. Fasten each guide rail with washer, lock washer
and bolt.
3. Push the roll-in cart (trolley) into the
Quickchiller and close the door.
4. At the front of the Quickchiller, make certain
contact has been made between the Quickchiller
and the cart along the total width of the door
to create a complete seal. When a full seal has
been determined, recheck each connection to
make certain it has been fully tightened.
caution
TO PREVENT PERSONAL INJURY,
USE CAUTION WHEN MOVING OR
LEVELING THIS APPLIANCE.
INSTALLATION
SITE INSTALLATION