Filter
Top Products
•
When lighting the surface burners, be
sure all of the controls are in the OFF
position. Strike the match first and hold
it in position before turning the knob.
•
Do not leave the cooktop unattended
when cooking during a power failure.
SURFACE COOKING
Settings Uses
HI Use HI to bring liquid to a boil, or reach pressure in a pressure
cooker. Always reduce setting to a lower heat when liquids begin
to boil or foods begin to cook.
An intermediate flame size is used to continue cooking. Food
will not cook any faster when a higher flame setting is used
than needed to maintain a gentle boil. Water boils at the same
temperature whether boiling gently or vigorously.
LOW Use LOW to simmer foods, keep foods warm and melt
chocolate or butter.
Some cooking may take place on the LOW setting if the pan is
covered. It is possible to reduce the heat by rotating the knob
toward OFF. Be sure flame is stable.
SUGGESTED HEAT SETTINGS
•
If flame should go out during a cooking
operation, turn the burner off. If a strong
gas odor is detected, open a window
and wait five minutes before relighting
the burner.
•
Be sure all surface controls are set to the
OFF position prior to supplying gas to
the cooktop.
•
NEVER touch cooktop until it has
cooled. Expect some parts of the
cooktop, especially around the burners,
to become warm or hot during cooking.
Use potholders to protect hands.
SURFACE
CONTROL KNOBS
Use to turn on the sur-
face burners. An infi-
nite choice of heat set-
tings is available from
LOW to HI. At the HI
setting a detent or
notch may be felt.
SETTING THE CONTROLS
1. Place a pan on the burner grate. (To
preserve the grate finish, do not operate
the burners without a pan on the grate to
absorb the heat from the burner flame.)
2. Push in knob and turn immediately coun-
terclockwise to the LITE setting.
❚ A clicking (spark) sound will be heard
and the burner will light. (All ignitors
will spark when any surface burner
knob is turned on. However, only
the selected burner will light.)
3. Turn knob to desired setting.
4. Do not leave cooktop unattended.
The size and type of cookware will affect the heat setting.
OPERATING
DURING A POWER
FAILURE
1. Hold a lighted match to the desired sur-
face burner head.
2. Push in and turn the control knob slowly to
the desired setting.
PILOTLESS
IGNITION
Pilotless ignition eliminates the need for a
constant standing pilot light. Each surface
burner has a spark ignitor. Use care when
cleaning around the surface burner.
If the surface burner does not light, check if
ignitor is broken, soiled or wet.
SURFACE
CONTROLS
4
CAUTION
CAUTION
IGNITOR
BURNER CAP
BURNER BASE
PORTS