Amana Bottom Freezer Refrigerator Refrigerator User Manual


 
5
How to reverse
refrigerator door
DOORS WITH TRIM AND
PANELS
1. Perform all steps listed in How to
Remove the Doors and Hinges.
2. Transfer cabinet
plugs and screws to
opposite side of
cabinet.
3. Remove plugs with flat blade of screw-
driver wrapped in masking tape.
4. Remove center mullion screws with
5
Ú16
" hex head driver.
IMPORTANT: When working directly on
doors, place doors on a nonabrasive sur-
face protected by towels or rugs to avoid
damage to door finish.
5. Locate door stop (A) and door cap (B)
on bottom edge of fresh food door.
Remove with a Phillips screwdriver.
Retain all items for later replace-
ment.
6. Remove top door extension with
1
Ú4"
hex head driver. Flip door extension
(A) so notched corner turns in toward
interior of door (B).
7. Remove side door trim (A) and handle
trim (B) from door by tapping bottom
edges upward with soft rubber mallet.
•Trim will slide up approximately
3
Ú4"
and release from door.
8. Replace bottom door cap removed
previously. Install door stop on oppo-
site side of door.
9. Retrieve alternate side door trim
shipped with refrigerator. Install trim
by aligning notches of trim with metal
mounting tabs on side of door.
Slide trim down until piece locks into
place.
•Tap top of trim with rubber mallet to
insure snug fit.
10. Remove tape from panels.
11. Proceed to How to Install and
Remove Handles to reinstall handle.
To avoid possible injury and damage
to property, tape decorative panels
(some models) securely into place
before removing side door trim and
handles.
WARNING
STANDARD
REFRIGERATOR DOOR
1. Perform all steps listed in How to
Remove the Doors and Hinges.
2. Transfer cabinet
plugs and cabinet
screws to opposite
side of cabinet.
3. Remove cabinet
plugs with flat blade screwdriver tip
wrapped in masking tape.
4. Remove center mullion screws with
5
Ú16" hex head driver.
5. Transfer door stop to opposite edge of
door using Phillips screwdriver.
IMPORTANT: When working directly on
doors, place doors on a nonabrasive sur-
face protected by towels or rugs to avoid
damage to door finish.
6. See How to Install and Remove
Handles to remove and reinstall
handles.
7. Proceed to How to Replace the
Doors and Hinges to mount doors.
B
A
B
A
A
B