5
• Remove toe grille to gain access to roller
adjustment screws.
CAUTION
!
To avoid property damage and damage to the unit, do
not use power tools to adjust leveling. Use hand tools
only.
• Turn rear roller adjustment screw clockwise to raise
corner that is rocking.
A
B
C
A. Rear roller adjustment screw C. Front roller adjustment screw
B. Door hinge screws
• Check alignment of top of doors. If doors are level
replace toe grille.
If tops of doors are not level perform the following steps:
• Remove toe grille.
• Determine which door needs to be lowered.
• To lower corner of door, turn front roller adjustment
screw counterclockwise.
• Roller adjustment screw should be turned until
doors are level.
A
A. Turn roller adjustment screw to lower door.
• If the unit has reached the bottom of its adjustment
range, and the doors are still not level–raise the
opposite door by turning its roller adjustment screw
clockwise.
B
B. Turn roller adjustment screw to raise door.
7. Review “Installation Checklist” in
Owner’s Manual with consumer.
Controls
This refrigerator is designed to operate at normal
household temperatures of 55° to 110°F (13° to 43°C).
Refrigerator and Freezer Controls
Refrigerator and freezer controls are located on upper rear
wall of refrigerator section.
A
B
A. Freezer control
B. Refrigerator control
When freezer control is set to
off
, neither refrigerator nor
freezer sections will cool.
Setting Controls
With setting
1
being the warmest and setting
7
being the
coldest, start by setting both controls to
4
.
Adjust controls by using a household thermometer that
includes temperatures between -5° to 50°F (-21° to 10°C).
Place thermometer snugly between frozen packages in
freezer section. Wait 5 to 8 hours. If freezer temperature
is not 0° to 2°F (-17° to -16°C), adjust freezer control by
one number at a time. Check temperature again after 5 to
8 hours.
Place thermometer in a glass of water in middle of
refrigerator section. Wait 5 to 8 hours. If refrigerator
temperature is not 38° to 40°F (3° to 4°C), adjust
refrigerator control by one number at a time. Check
temperature again after 5 to 8 hours.