Filter
Top Products
26
Troubleshooting,
cont.
Ice and water, cont.
Ice maker is not
producing ice
Water filter indicator light
is red
Refrigerator is leaking
water
Ice forms in inlet tube
to ice maker
Water flow is slower
than normal
Dispenser water is not
cold
Ice maker arm is not in correct position.
Household water supply is not reaching water
valve
Copper or plastic tubing has kinks.
Water pressure is too low.
Check freezer temperature.
Ice bin is not installed properly
Improper water valve was installed.
Water filter needs to be replaced.
Filter indicator sensor needs to be reset.
Plastic tubing was used to complete water
connection.
Improper water valve was installed
Water pressure is low.
Freezer temperature is too high.
Water pressure is too low.
Improper water valve was installed.
Copper or plastic tubing has kinks.
Water filter is clogged or needs to be
changed.
Refrigerator has been recently installed.
Water supply in holding tank has been
depleted.
Water has settled into water lines outside
holding tank and has warmed to room
temperature.
Confirm ice maker arm is down. See Freezer Features
section in your owner’s manual for details
Check water connection procedure written in Installing Your
Refrigerator.
Turn off water supply and remove kinks. If kinks cannot be
removed, replace tubing.
Water pressure must be between 20 to 100 pounds per square
inch to function properly. A minimum pressure of 35 pounds per
square inch is recommended for refrigerators with water filters.
See temperature controls section in Setting and Maintaining
Proper Temperature to adjust your controls. Freezer must be
between 0 to 2° F (-18 to –17° C) to produce ice.
See ice bin section for proper installation and alignment.
Check water connection procedure in Installing Your
Refrigerator. Self-piercing and
3
⁄16” saddle valves cause low
water pressure and may clog the line over time. The
manufacturer is not responsible for property damage due
to improper installation or water connection.
If filter is not available, replace with bypass filter. See
Dispenser Features section for directions.
See Dispenser Features section for directions.
The manufacturer recommends using copper tubing for
installation. Plastic is less durable and can cause leakage.
The manufacturer is not responsible for property damage
due to improper installation or water connection.
Check water connection procedure in Installing Your
Refrigerator. Self-piercing and
3
⁄16
” saddle valves cause low
water pressure and may clog the line over time. The
manufacturer is not responsible for property damage due
to improper installation or water connection.
Water pressure must be between 20 to 100 pounds per
square inch to function properly. A minimum pressure of 35
pounds per square inch is recommended for refrigerators with
water filters.
See temperature controls section in Setting and Maintaining
Proper Temperature to adjust your controls. Freezer must be
between 0 to 2° F (-18 to –17° C) to produce ice.
Water pressure must be between 20 to 100 pounds per
square inch to function properly. A minimum pressure of 35
pounds per square inch is recommended for refrigerators with
water filters.
Check water connection procedure in Installing Your
Refrigerator. Self-piercing and
3
⁄16” saddle valves cause low
water pressure and may clog the line over time. The
manufacturer is not responsible for property damage due
to improper installation or water connection.
Turn off water supply and remove kinks. If kinks cannot be
removed, replace tubing.
Change water filter.
Allow approximately 12 hours for water in holding tank to chill.
Discard first glass of water and refill.