Filter
Top Products
English
6
U
npacking Your Wine Cellar
1. Remove all packaging material. This includes the foam base and all adhesive tape
holding the wine cellar accessories inside and outside.
2. Inspect and remove any remains of packing, tape or printed
m
aterials before powering on the wine cellar.
Leveling Your Wine Cellar
•
Your wine cellar has four leveling legs which are located in the front and rear corners of your wine cellar.
After properly placing your wine cellar in its final position, you can level your wine cellar.
• Leveling legs can be adjusted by turning them clockwise to raise your wine cellar or by turning them coun-
terclockwise to lower your wine cellar. The wine cellar door will close easier when the leveling legs are
extended.
Electrical Requirement
• Make sure there is a suitable power Outlet (115 volts, 15 amps outlet) with proper grounding to power
the wine cellar.
• Avoid the use of three plug adapters or cutting off the third grounding in order to accommodate a two
plug outlet. This is a dangerous practice since it provides no
effective grounding for the wine cellar and may result in shock hazard.
Use of Extension Cords
• Avoid the use of an extension cord because of potential safety hazards under certain conditions. If it is
necessary to use an extension cord, use only a 3-wire extension cord that has a 3-blade grounding plug
and a 3-slot outlet that will accept the plug. The marked rating of the extension cord must be equal to or
greater than the electrical rating of the appliance.
INSTALLING YOUR WINE CELLAR
WARNING
CAUTION