Filter
Top Products
8
4. Insert 2 screws with washers through top cabinet
holes and tighten to top of microwave oven. (While
tightening screws, lift front side of microwave oven
and push toward wall.)
5. Install rectangular washer under microwave oven for
extra stability. Rectangular slot is located under
microwave oven, inside left grease filter area.
9. Install grease filters.
10. For top exhaust, open top cabinet and attach exhaust
adaptor to microwave oven through cabinet bottom.
For front-to-back or side-to-side adjustment, slide
exhaust adaptor as needed.
Twist exhaust adaptor to fit under flaps of blower
plate. Verify damper moves freely. Square corner on
hinge ends.
11. Pull house duct down to connect to exhaust adaptor.
G. Installation Checklist
1. Verify microwave oven has been installed according
to instructions.
2. Remove all packing material from microwave oven.
3. Replace house fuse or turn on breaker.
4. Plug power cord into outlet.
5. Read use and care manual.
3. Attach microwave oven to top cabinet. Use filler block
if cabinet front hangs below cabinet bottom shelf.
6. Use rectangular washer to mark hole for drilling in left
side rectangular slot. Place washer in slot by
grasping "ears" on washer to center in opening. Mark
location of hole on rear wall with pencil. Center
carefully to assure good fit.
7. Drill small pilot hole with 1/8 inch drill to determine if
stud is behind hole. If stud is found, drill 3/16 inch
diameter hole for wood screw; if no stud is found, drill
5/8 inch diameter hole for toggle bolt.
8. If stud is found, use wood screw to attach rectangular
washer lightly to wall. Twist washer 90° to lock before
tightening. If no stud is found, use toggle bolt to
attach rectangular washer lightly to wall. Twist
washer 90° to lock before tightening.
F. Mounting Microwave Oven
1. Locate grease filters packed separately and set aside.
Thread power cord through hole, or slot, in bottom of
top cabinet. Keep cord tight throughout step 2.
2. Install microwave by sliding onto arms of mounting
plate. Push microwave oven flush to wall. Verify cord
is tight.