Filter
Top Products
7
Installation
Radio Interference
Microwave oven operation may cause interference to radio, TV, or similar equipment. To reduce or eliminate
interference:
• Clean door and sealing surfaces of oven. See "Care and Cleaning" instructions on page 56.
• Place the radio, TV, etc. away from oven.
• Use properly installed antenna on radio, TV, etc. to obtain stronger signal reception.
Unpacking Oven
• Inspect microwave oven for damage such as dents
in door or dents inside oven cavity.
• Report any dents or breakage to source of purchase
immediately. Do not attempt to use damaged oven.
• Remove all packing and printed materials from oven
interior.
• Remove turntable from foam pad, located at bottom
of carton.
• If oven has been stored in extremely cold area, wait
a few hours before plugging in.
Power Supply Cord
A short power supply cord is provided to reduce risks of becoming entangled in or tripping over a longer
cord.
• Longer cord sets or extension cords are available and may be used if care is exercised in their use.
• If a long cord or extension cord is used, (1) the marked electrical rating of the cord set or extension cord
should be at least as great as the electrical rating of the appliance, (2) the extension cord must be a
grounding type 3 wire cord, and (3) the longer cord should be arranged so that it will not drape over the
countertop or tabletop where it can be pulled on by children or tripped over accidentally.
Microwave Power
Models RW635T, RL635T and RBG635T deliver 1000 watts, based on IEC 705 test method, of microwave
power to the oven cavity.
Built-In Capability
Oven Placement
Do not build oven in with sides, top or bottom airflow
restricted. Oven must have sufficient airflow around
it. Air flows around electric components. At least
one inch of clearance is required at top and sides of
oven to provide proper ventilation. With restricted
air flow oven will not operate properly and life of
electrical parts shortens.
To build-in, use only Amana "RS" trim kit. Trim kit
will have a label identifying which oven models may
be used.