Filter
Top Products
5
Unpacking Equipment
• Inspect equipment for damage such as dents in door or
dents inside oven cavity.
• Report any dents or breakage to source of purchase
immediately. Do not attempt to use oven if damaged.
• Remove all materials from oven interior.
• If oven has been stored in extremely cold area, wait a
few hours before connecting power.
Equipment Placement
• Do not install equipment next to or above source of
heat, such as pizza oven or deep fat fryer. This could
cause microwave oven to operate improperly and could
shorten life of electrical parts.
• Do not block or obstruct oven filter. Allow access for
cleaning.
Radio Interference
Microwave operation may cause interference to radio,
television, or similar equipment. Reduce or eliminate
interference by doing the following:
• Clean door and sealing surfaces of oven according to
instructions in “Care and Cleaning” section.
• Place radio, television, etc. as far as possible
from oven.
• Use a properly installed antenna on radio, television,
etc. to obtain stronger signal reception.
InstallationGrounding Instructions
This equipment MUST be grounded. In the event of an
electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric
current. This oven is equipped with a cord having a
grounding wire with a grounding plug. The plug must be
plugged into an outlet that is properly installed and
grounded.
Consult a qualified electrician or servicer if grounding
instructions are not completely understood, or if doubt
exists as to whether the equipment is properly grounded.
Do not use an extension cord. If the product power cord
is too short, have a qualified electrician install a three-slot
receptacle. This oven should be plugged into a separate
60 hertz circuit with the electrical rating as shown in the
appropriate drawing. These models require a 120 supply
voltage. When a microwave oven is on a circuit with other
equipment, an increase in cooking times may be required
and fuses can be blown.
To avoid the risk of electrical shock or death, do not
alter the plug.
WARNING
To avoid the risk of electrical shock or death, this
equipment must be grounded.
WARNING
NEMA 5-20R/5-20P
120V–20AMP
RFS9*
RFS11*