9
Preprogrammed Number Pads
1. Open oven door.
• Fan and light operate.
• If door is closed or
RESET
pad is pressed before
finishing programming sequence, oven exits
programming mode.
2. Press and hold pad
1
for approximately 15 seconds.
• After 15 seconds, signal sounds. Display shows
“P” programming mode.
3. Press numbered pad to be programmed.
4. Press number pads to enter desired cooking time.
• For example, to heat for 2 minutes 30 seconds,
press
2
,
3, and 0
pads.
5. Press
START
pad to save new heating time and
power level in oven memory.
• Repeat step 3 and 4 to program additional pads.
6. Press
RESET
pad or close oven door to exit
programming mode.
Multiple Heating Stages
Oven can be programmed to perform 4 independent
heating cycles without interruption.
1. Open oven door.
• Fan and light operate.
• If dooris closed or
RESET
pad is pressed before
finishing programming sequence, oven exits
programming mode.
2. Press and hold pad
1
for approximately 15 seconds.
• After 15 seconds, signal sounds. Display shows
“P” programming mode.
3. Press numbered pad to be programmed.
4. Press number pads to enter desired cooking time.
• For example, to heat for 2 minutes 30 seconds,
press
2
,
3, and 0
pads.
5. Press
TIME ENTRY
pad.
• Display briefly shows "P1
(1-9,0)
" programming mode,
stage, and pad. Then cook time for stage shows in
display.
6. Press
START
pad to save new heating time and
power level in oven memory.
• Repeat steps 3-5 to create additional stages.
7. Press
RESET
pad or close oven door to exit
programming mode.
Programming
Deactivating Numbered Pad
1. Open oven door.
• Fan and light operate.
• If door is closed or
RESET
pad is pressed before
finishing programming sequence, oven exits
programming mode.
2. Press and hold pad
1
for approximately 15 seconds.
• After 15 seconds, signal sounds. Display shows
“P” programming mode.
3. Press numbered pad to be deactivated.
4. Press hidden pad.
5. Press
START
pad.
• “dd:dd” shows in display.
• To reactivate control repeat steps 1-5.
1
2
Hidden
Pad