Filter
Top Products
6
Touchmatic
™
Electronic Controls
(some models)
Locate power switch on right side of black box in center of
cabinet behind toe grille. Turn power switch on before
programming.
Touchmatic
™
electronic controls are located on refrigerator
between door handles. Press * pad to activate control
panel. All other pads, except for
ALARM OFF
pad, remain
inactive until * pad is pressed. Once activated, pads
remain programmable for at least 10 minutes.
Refrigerator and freezer controls are preset at
5
. Wait
24 hours after connecting power for refrigerator and freezer
sections to reach desired temperatures. After 24 hours,
adjust controls as desired. 1 is warmest setting and 9 is
coldest. Refer to “Setting Controls” section to set controls
precisely.
• Adjust refrigerator or freezer temperatures by pressing
* pad then
REFRIG TEMP
pad or
FREEZER TEMP
pad. Press
WARMER
pad or
COLDER
pad to adjust
temperature setting 1 level at a time. Holding down
WARMER
pad or
COLDER
pad adjusts temperature
more than 1 level at a time.
Controls
This refrigerator is designed to operate at normal
household temperatures of 55° to 110°F (13° to 43°C).
Refrigerator and Freezer Controls (non
electronic models)
Refrigerator and freezer controls are located on upper rear
wall of refrigerator section.
A
B
A. Freezer control
B. Refrigerator control
Controls
When freezer control is set to
off
, neither refrigerator nor
freezer sections will cool. Initially, set both controls to
4
.
Wait 24 hours for refrigerator and freezer sections to
reach desired temperatures. 1 is warmest setting and 7 is
coldest.
Setting Controls
Set controls with a household thermometer that includes
temperatures between -5°– 50°F (-21°–10°C).
Put thermometer snugly between frozen packages in
freezer section. Wait 5–8 hours. If freezer temperature is
not 0°–2°F (-17°– -16°C), adjust control, 1 number at a
time. Check again after 5–8 hours.
Put thermometer in a glass of water in middle of
refrigerator section. Wait 5–8 hours. If refrigerator
temperature is not 38°–40°F (3°–4°C), adjust control, 1
number at a time. Check again after 5–8 hours.