APW Wyott M2000 Toaster User Manual


 
TROUBLESHOOTING GUIDE
Always ask and check the following:
1. Is the unit connected to a live power source of the proper voltage?
2. Check the circuit breaker.
3. Is power switch “ON” and pilot light glowing?
4. Check the rating label. Is the unit connected to the correct power source?
If the above checks out, and you still have problems, call an APW Wyott authorized service agent.
APW SERVICE HOT LINE 1-800-733-2203
Buns wont toast Wrong temperature setting
Excessive cupping of bun
surface
Increase temperature setting
and allow two cycles to warm
up.
Buns may be stale. Try fresher
buns
Buns toast unevenly Excessive cupping of bun
surface
Conveyor pressure too light
Buns may be stale. Try fresher
buns
Adjust conveyor tension
Buns stick to grill Teflon sheet worn.
Doughy buns or excessive
sugar and moisture, plus grill
temperature too high.
Build up on Grill Surface
Replace Teflon sheet
Reduce grill temperature
Allow buns to age.
Clean Grill per instructions
No power No power at the wall
receptacle
Power cord disconnected
Main switch
Check circuit breaker or fuse
Check plug at receptacle
Check that switch is ON and
operative
Conveyor will not turn (Motor
turns)
Drive gears not engaged
Gear set screws not tight
Check gear alignment and
engagement
Check screws and tighten if
required
PROBLEM CAUSE SOLUTION
PROBLEM
CAUSE
SOLUTION
7