Filter
Top Products
TABLE OF CONTENTS:
SECTION ITEM PAGE
1 Safety Precautions 2
2 General Installation Instructions 4
3 Specifications 5
4 Lighting Instructions 6
5 Operating Instructions 7
6 Cleaning/Maintenance 8
7 Troubleshooting Guide 9
8 Replacement Parts Lists & Exploded Views 10
9 Warranty 15
LOCATION OF DATA PLATE
The data plate is located on the back side of the front panel.
IMMEDIATELY INSPECT FOR SHIPPING DAMAGE
All containers should be examined for damage before and during unloading. The freight carrier has
assumed responsibility for its safe transit and delivery. If equipment is received damaged, either apparent or
concealed, a claim must be made with the delivering carrier.
A) Apparent damage or lossmust be noted on the freight bill at thetime of delivery. It must then be signed by
the carrier representative (Driver). Ifthis is not done, the carrier may refuse the claim.The carrier can supply
the necessary forms.
B) Concealed damage or loss if not apparent until after equipment is uncrated, a request for inspection
must be made to the carrier within 15 days. The carrier should arrange an inspection. Be certain to hold all
contents and packaging material.
Installation and start-up should be performed by a qualified installer who thoroughly read, understands and
follows these instruction.
If you have questions concerning the installation, operation, maintenance or service of this product, write
Technical Service Department APW Wyott Foodservice Equipment Company, P.O. Box 1829, Cheyenne,
.
2. GENERAL INSTALLATION INSTRUCTIONS:
Ensure gas supply and gas type, as shown onunit nameplate agree.
Unit installation must conform with the National Fuel Gas Code, ANSI Z223.1-1996, the National Gas
Installation Code, CAN/CGA-B149.1, or the Propane Installation Code, CAN/CGA-B149.2 as applicable
and in accordance with localcodes.
Screw legs into the permanently fastened nuts on the four cornersof the unit and tighten by hand. Level the
unit by turning the adjustment screw at the bottom of each leg. Do not slide unit with legs mounted, lift if
necessary to move unit.
Pipe gas supply to unit.
Pipe threading compound must be resistant to the action of liquefied petroleum gases.
These units are suitable for installation on noncombustible surfaces only.
!
!
Caution: DO NOT use an open flame to check for leaks. Check all gas piping for leaks
with a soap and water solution before operating unit.