Filter
Top Products
6
Caution: External Surface Temperatures
The unit's external surface temperatures will be hot. Use caution when touching these areas to
avoid injury.
Warning: Severe Burns - Ceramic Heaters
The white ceramic heaters operate at high temperatures. Do not touch elements after power
is applied to the elements. Incorporated into the front surface of the element is a red color
changing decal. As the element reaches a predetermined temperature, the decal will change
from red to black. The decal will remain black until the element falls below the transition
temperature where it will then return to its original red color. However, the element even if red
will still be extremely hot. This color changing feature is used ONLY for determining if element is
operating properly.
5. The deflector curtains located at the entrance and exit of the unit are used to contain the heat inside
the unit, as well as keep any forced drafts from entering the unit. These curtains aid in efficient
operation of the heaters and can be adjusted to increase or decrease the entrance and exit height.
These curtains should be adjusted to the minimum height required above the conveyor for the
product you are heating.
Control Operation
This oven has 2 heating zones, 1 on top, and one in the bottom. The top zone (Top Heat) is used to
control all 5 ceramic emitters. The bottom zone (Bottom Heat) is used to control the bottom element.
6. CLEANING
Insure the appliance has been turned off and has had sufficient time for all surfaces to cool down before
cleaning. Use only mild soap and water to clean this appliance. Appliance cleaning should be performed daily.
NOTE: DO NOT USE ABRASIVE PADS OR CLEANING SOLUTIONS ON THIS APPLIANCE.
Daily Cleaning
Remove the crumb pans and wipe out debris with a damp rag and mild soap solution.
Remove the deflector panels located at the entrance and exit of the oven tunnel. Wipe down the area
under the deflector panels, and the deflector panels, with a damp rag and mild soap. Reinstall the
deflector panels by reversing the procedure used to remove them.
Using a damp rag with mild soap and water, wipe down the exterior surfaces of the appliance.
Using a damp rag with mild soap solution, wipe down all areas of the conveyor. DO NOT ATTEMPT TO
CLEAN THE UPPER WHITE CERAMIC, OR LOWER METAL HEATERS.
When units are in the stacked configuration, it is still necessary to clean between the units. Using a
damp rag with mild soap and water, wipe down the tops and undersides of all units. Ensure there are no
foreign objects between the units that could catch fire.
Using a damp rag with mild soap and water, wipe the surfaces of the stacking spacers on all four
corners.
7. TROUBLESHOOTING
Always ask and check the following:
Not getting power:
1. Is the unit connected to a live power source of the proper voltage?
2. Check the rating label. Is the unit connected to the correct power source?
3. Check the circuit breaker.
4. If the above checks out, and you still have problems, call your local service agent.