Filter
Top Products
2. GENERAL INFORMATION
1. Overall Dimensions w/Wire Feeder - 13.610”H (34.5cm) x 15.192”W (38.6cm) x 17.982”D (45.7cm)
2. Product Opening - 1.50”H (3.8cm) x 10.50”W (26.7cm)
3. Electrical Requirements (Single phase):
A. 120 Volt, 1800 Watt, 15 Amp.
B. 208 Volt, 1800 Watt, 8.5 Amp.
C. 230/240 Volt, 1800 Watt, 7.8 Amp.
D. Cordset configuration
1. Each toaster equipped with three wire grounded cordset and standard three-prong plug.
2. In the U.S.: 120V uses NEMA 5-15P. 208, 230/240V uses NEMA 6-20P .
3. In Canada: 120V uses NEMA 5-20P.
4. Net/Shipping Weight – 28 lb.(12.7kg) / 33 lb.(14.97kg)
3. INSTALLATION INSTRUCTIONS
I. Check Contents - refer to Figure 1, account for the following parts:
A. Wire Feeder - inside Reflector Tray
B. Reflector Tray - shipped in place
C. Toast Drawer - shipped in place
D. Instruction Manual - shipped loose
2. Position Wire Feeder
A. Pull out Reflector Tray
B. Rotate Wire Feeder
C. Slide Reflector Tray back
D. WARNING: Operating toaster without Reflector Tray reduces toasting capabilities.
3. Toaster Placement
A. Locate toaster near a grounded receptacle of the proper configuration (see below). Plug
the cordset directly into receptacle (DO NOT USE AN EXTENSION CORD).
1. In the U.S.: 120V uses NEMA 5-15R. 208, 230/240V uses NEMA 6-20R.
2. In Canada: 120V uses NEMA 5-20R.
B. Place toaster on flat surface providing following minimum clearances:
1. Base = one inch (provided with legs installed).
2. Side and back walls = two inches
3. Overhead = Enough space to allow adequate heat displacement.
C. Position toaster where customers will not contact any surface labeled “CAUTION HOT”.
4. OPERATION INSTRUCTIONS
1. Preparation
A. Clean toaster thoroughly before first use (See cleaning instructions).
B. Controls Familiarity
1. Main Power Switch (located on very bottom of control panel): There are two rocker switches.
The bottom switch powers the unit “ON”. It also turns on the bottom element. The top switch is
a standby switch (upper heat switch) that runs the top element. When the standby switch is in
the “ON” position the unit is at full power. When the standby switch is in the “OFF” position the
unit is running at 50%.
a) Full Power: Flip both rocker switches to the right.
b) Power Off: Flip both rocker switches to the left.
2. Conveyor Speed Control: Set knob to the three (3) position for warm-up.
C. Warm-up time: Allow five (5) minutes.
2. Normal Use
A. Loading Product
1. Place product on Wire Feeder. The conveyor will automatically draw product through the
toaster at a speed determined by conveyor speed control.
5
C
B
A
Figure 1