Filter
Top Products
9
GB
Cleaning and Special Maintenance
Filter Assembly
For best performance and results, the filter assembly must
be cleaned .
The filter efficiently removes food particles from the wash
water, allowing it to be recirculated during the cycle. For
this reason, it is
a good idea to
remove the
larger food
particles
trapped in the
filter after each
wash cycle by
rinsing the "A"
semi-circular
filter and cup under running water. To remove the filter
assembly, pull on the cup handle in the upward direction.
The entire filter assembly (made up of the "A" semicircular
filter and the "B" fine filter) should be cleaned at least
once a month.
To clean the filter and the fine filter, use a cleaning brush.
Then, reassemble the filter parts as shown in the figures
below and reinsert the entire assembly in the dishwasher,
positioning in its seat and pressing downward.
The dishwasher must
never be used without
the filters. Improper
replacement of the filters
may reduce the perfor-
mance level of the
appliance and damage
dishes and utensils.
Cleaning the Sprayer
Arms
It may happen that food
particle become encrusted on the sprayer arms and block
the holes (see "Close up view (interior)", letters F-I). Check
the sprayer arms periodically and clean them when needed.
Cleaning the Water Inlet Filter
Periodically clean the water inlet filter (see figure 2 under
"Installation") located on the outlet of the water supply
tap. After turning off the water tap, unscrew the end of
the water supply hose, remove the filter and clean it carefully
under running water. Then, return the filter to its place and
tighten the water supply hose back into position.
Troubleshooting
It may occur that the dishwasher does not function or does
not function properly. Before calling for assistance, let us
see what can be done first: have you forgot to press one of
the buttons or to perform an essential operation?
The Dishwasher Does Not Start
Have you checked whether:
- the plug is pushed into the socket correctly;
- the power is on in the house;
- the door is closed properly;
- the ON-OFF switch is on "ON";
- the water supply is turned on.
The Dishwasher Does Not Load Water
Have you checked whether:
- the water is turned on and the hose is connected properly;
- the water supply to the house is on and has sufficient
pressure;
- the water supply hose is crimped or bent;
- the filter for the water supply hose is clogged.
The Dishes Are Not Clean
Have you checked whether:
- the water is turned on and the hose is connected properly;
- the water supply to the house is on and has sufficient
pressure;
- the water supply hose is crimped or bent;
- the filter for the water supply hose is clogged.
The Dishwasher Does Not Drain
Have you checked whether:
- the drain hose is crimped or bent.
Lime Deposits or a White Film Form on the Dishes
Have you checked whether:
- the lid to the salt container is closed properly;
- the rinse aid dosage is correct.
If, despite all these checks, the dishwasher still does not
function and/or the problem persists, contact the nearest
authorised service centre and provide them with the
following information:
- the nature of the problem;
- the model type number (Mod. ...) and the serial number
(S/N ....), which are indicated on the plate located on the
side of the inner part of the door.
Never call on unauthorised technicians and refuse to
allow parts to be installed that are not original spare
parts.
A
B