Filter
Top Products
17
N.B: Use the clamps contained in the "accessory kit."
f) In the event the cooktop is not installed above a built-in oven,
a wood panel must be inserted as insulation. This panel must
be placed at least 20 mm from the bottom of the cooktop
itself.
Important: When installing the cooktop above a built-in oven,
the oven should be placed on two wooden strips; in the case of
a joining cabinet surface, remember to leave a space of at least
45 x 560 mm at the back.
560 mm.
45 mm.
When installing the cooktop above a built-in oven without forced
ventilation, ensure that there are air inlets and outlets for ventilating
the interior of the cabinet adequately.
Gas Connection for Cooktop
The cooktop should be connected to the gas supply by an
authorized installer. During installation of this product it is essential
to fit an approved gas tap to isolate the supply from the appliance
for the convenience of any subsequent removal or servicing.
Connection of the appliance to the gas mains or liquid gas tanks
must be carried out according to the safety standards currently
in force, and only after it is ascertained that it is suitable for the
type of gas to be used. If not, follow the instructions indicated in
the section entitled, “Adapting the Cooktop for Different Types of
Gas”. If the cooktop is to be connected to tanks containing liquid
gas, use pressure regulators that comply with current safety
standards.
Important: To insure that the appliance operates safety, the gas
is regulated correctly and your appliance lasts over time, make
sure that gas pressure levels comply with the indications given
in Table 1, “Nozzle and Burner Specifications”.
Gas Connection to Non-flexible Pipe
(copper or steel)
Connection to the gas source must be done in such a way as to
not create any stress points at any part of the appliance.
The appliance is fitted with an adjustable, "L" shaped connector
and a gasket for the attachment to the gas supply. Should this
connector have to be turned, the gasket must be replaced
(supplied with the appliance).
The gas feed connector to the appliance is a threaded, male 1/
2" connector for round gas pipe.
at a height from the top which allows easy use of pots and
pans on the cooker.
d) Should the cooktop be installed directly under a cupboard,
the latter should be at least 700 mm (millimetres) from the
top, as shown in Figure.
600mm min.
540mm min.
700mm min.
e) The dimensions of the cutout for the appliance must be those
indicated in the figure. Clamps are provided to fasten the
cooktop to counters measuring from 20 to 40 mm in thickness.
To fasten the cooktop securely, it is recommended that all the
clamps be used.
555
mm
475
mm
55
mm
Fastening Clamps - Assembly Diagram
Clamp Position for Clamp Position for
H=20mm top H=30mm top
Front
Clamp Position for
H=40mm top Back