Filter
Top Products
Main Confi
g
uration Window
–
Channel Settin
g
Tab (Continued)
The software can configure the following channel functions:
Copy Channel Information (CH1 CP) button
Clicking this button copies channel one’s settings to the other
seven channels
.
INPUT ATT
Allows selection between 0 dB (MIC) and –35 dB (LINE) level
inputs.
(Note: if LINE is selected, Phantom will be OFF
and if PHANTOM is ON, MIC will be selected.)
PHANTOM
Turns 48V phantom power on or off.
PRIORITY
Sets the channel’s priority status.
LOW FREQ CUT
Turns on the channel’s roll-off filter to minimize mechanical or
other low-frequency noise.
FORCE ON
Allows channel to turn on, when external contact closure is
activated, overriding any priority settings.
Note: Force on/off settings from external contact closure will
override force on/off settings from PC.
FORCE OFF
Allows channel to turn off when external contact closure is
activated, overriding any priority settings.
GATE ATT
When a channel is closed, its output is not entirely cut off, but
attenuated. GATE ATT sets the amount of attenuation when the
channel gate is closed (channel is off).
DIRECT OUTPUT
Allows the signal on each channel to appear on the Direct Out
terminal before or after the channel’s gate.
INITIALIZE
Clicking these buttons sets a channel or all channels to factory default settings.
Note: when any of the INITIALIZE or CH1 CP buttons are clicked, a confirmation box appears, clicking OK
begins the process. During the process, a blue progress bar appears in the rectangle in the windows lower
left corner.
8