Filter
Top Products
10
OPERATING YOUR ICE MAKER
Control Panel Description
Ice Size Selector (D)
ICE SIZE SELECTION of (S) Small or (L) Large.
The default cube size from the factory is set at SMALL.
Each time you press this button the cube size selection will change 1 size (Small or Large) in
sequence.
The chosen mode shall stay as selected unless changed or there is a power failure.
For the most efficient operation when ambient temperature is below 15°C (59ºF) use the small
cube size setting.
LED INDICATORS
ICE SIZE INDICATOR (C)
Cube size selection is shown (S) Small or (L) Large.
The indicator next to the selected cube size will be illuminated green.
ADD WATER INDICATOR (A).
The ice maker automatically checks the water level in the tank. If the water level is too
low the indicator will illuminate in RED and will stop working automatically. Once you add
water to the unit the indicator will turn off and will resume normal operation.
ICE FULL INDICATOR (RED) (B).
When the ice-bin is full, the indicator will illuminate in RED.
The indicator will remain lit even if the ice in the bin either melts away slowly or has been
removed. The unit will stay in a “STANDBY” mode for approximately 6 hours. To restart
the ice-making process push the “STOP” button, remove all of the ice from the ice-bin,
wait for approximately 3 minutes and then press the “START” button. The ice-making
process will return to normal mode.
A ADD WATER or Tank Empty Indicator
B ICE BIN FULL Indicator
C Cube Size Selection Indicator (Large / Small)
D Cube Size Selector Button
E Power ON Indicator
F Power ON / OFF Button