Filter
Top Products
12
All parts removed must be saved to do the replacement of the light bulb.
Before removing the light bulb, either unplug the appliance or disconnect the electricity leading
into the appliance at the main power supply. Failure to do so could result in electrical shock or
personal injury.
? Press the light switch to the “OFF” position.
? Remove the screw “5”.
? Remove the light bulb cover “4” by pulling the bottom end of the light bulb cover gently.
? Unscrew the bulb “2”.
? Replace with a 10-watt bulb that is the same shape and size.
? Replace the light bulb cover “4” and tighten screw “5”.
1 – Bulb Holder 4 – Bulb Cover
2 – Bulb 5 – Screw
3 – Bulb Holder Case
CLEANING YOUR APPLIANCE
? Unplug the appliance, and remove shelves .
? Wash the inside surfaces with a warm water and baking soda solution. The solution should be
about 2 tablespoons of baking soda to a quart of water.
? Wash the shelves with a mild detergent solution.
? The outside of the appliance should be cleaned with mild detergent and warm water.
? Wring excess water out of the sponge or cloth before cleaning the area of the controls, or any
electrical parts.
? Wash the ou tside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry
with a clean soft cloth.
CAUTION:
Failure to unplug the appliance could result in electrical shock or personal injury.
POWER FAILURE
Most power failures are corrected wi thin a few hours and should not affect the temperature of your
appliance if you minimize the number of times the door is opened. If the power is going to be off for a
longer period of time, you need to take the proper steps to protect your food.
NOTE:
? If the unit is unplugged, has lost power, or is turned off; you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the appliance will not start.
VACATION TIME
? Short vacations: Leave the appliance operating during vacations of less than three weeks.
? Long vacations: If the appliance will not be used for several months, remove all items and
unplug the power cord. Clean and dry the interior thoroughly. To prevent odor and mold growth,
leave the door open slightly: blocking it open if necessary.