Filter
Top Products
Electric Pressure Fryer Operation
12
Item # Description Function
1 Spin Handle Used to tighten the lid to the pot once it is latched.
2 Pop Safety Valve lever Used to release pressure periodically to prevent the seat from
sticking.
3 Pressure Gauge Indicates the pressure inside the pot.
4 Computer Used to program the cooking computer and activate the
programs.
5 Rocker Switch FILTER – When placed in this position, power is applied to the
motor and shorting is pumped into the pot directly or thru the fill
hose.
OFF – When placed in this position, power is removed from both
the pump motor and heating elements.
FRY – When placed in this position, power is supplied to the
thermostat and heating elements.
6 Thermostat Knob Used to set the temperature of the shortening.
7 Thermostat Light Illuminates red indicating that the heating elements are activated.
8 Digital Timer The digital timer consists of an LED, display, beeper and 8
buttons described below:
LED indicator Prior to the start of a timing cycle the LED will be OFF. When
running a timing cycle the LED will flash. At the end of a timing
cycle the LED will turn ON steady. When idle the LED is off.
TIME SELECT (2
arrow buttons)
Two arrow buttons on the front panel are used to set the time.
Hold the UP ARROW button down to increase the time. The
longer the button is held down, the faster the rate at which the
time will increase. The DOWN ARROW button is used in the
same manner as the UP ARROW button except it will cause the
time to decrease. The time is increased or decreased in 30-
second increments.
START/STOP
button
Starting the Timer - Pressing this button while the timer is not
active will cause the timer to begin counting down the time on the
display.
Stopping the Timer - Pressing this button while the timer is
active will stop the timer from counting down and display the
remaining time. Time cannot be changed with the TIME SELECT
buttons at this point. If this button is pressed again the timer will
continue counting down from the point it was stopped.
Resetting the Timer - Pressing and holding this button for longer
than two (2) seconds will reset the timer and the display will return
to the original starting time. At this point, time can be changed
using the TIME SELECT buttons or the preset buttons.
Canceling The STIR OIL Function - Pressing this button cancels
the STIR OIL function while it is active.