Filter
Top Products
Gas Pressure Fryer Operation
14
Item Description Function
8 A, B, C, D preset
buttons
These buttons are used to save and recall preset cycle and alarm times,
saving operator time and minimizing error when changing interval cycle
times and alarm times. To save the current interval and alarm times into
one of the preset locations, press and hold the A, B, C, or D preset button
for 2 seconds and the controller will double chirp to indicate the times have
been saved. To recall any preset time, press and quickly release the
appropriate button and the time values are loaded and displayed. These
buttons are also used to reconfigure the STIR OIL function.
Beeper A beeper sounds when the timer counts down to 0. Pressing the
START/STOP button stops the beeper and resets the timer causing the
display to return to the original starting time. At this point, time can be
changed using the TIME SELECT buttons or the preset buttons. The
beeper will also sound for 10 seconds if the alarm time has elapsed during
a timing cycle. When the STIR OIL function begins the beeper will sound
until the ALARM or START/STOP button is pressed.
Display Used to display the time. It also displays the words “STIR” then “OIL” in .5
second intervals until the ALARM or START/STOP button is pressed.
9 High Limit Reset Switch If shortening inside the pot reaches an unsafe temperature, power is
automatically removed from the control panel and the gas system shuts
off. Pressing this switch returns power to the control panel and resets the
gas system.
10 Gas Control Valve Switch ON – Allows gas to flow when the FILTER/OFF/FRY switch is set to the
FRY position and the thermostat calls for heat.
OFF – Prevents gas flow regardless of FILTER/OFF/FRY switch and
thermostat settings.
11 Drain Lever DRAIN OPEN – When placed in this position, the drain valve opens and
shortening drains into the vat. Also power is removed from the control
panel and gas system.
DRAIN CLOSED – When placed in this position, the drain valve is closed
to prevent shortening from draining into the pot. Also power is restored to
the control panel and gas system.
12 Fill Lever FILL THRU POT – When placed in this position, shortening will be pumped
from the vat to the pot if the rocker switch is in the FILTER position.
FILL THRU HOSE – When placed in this position, shortening will be
pumped from the vat to the pot via a fill hose if the rocker switch is in the
FILTER position.
13 Pump Motor Reset Switch If the motor overheats while filtering, it will automatically shut off. Wait 15
minutes to allow motor to cool before pressing this switch.
14 Rinse Hose Connector Used to connect the Rinse hose for cleaning and refilling the pot.