Filter
Top Products
5
Dry Wall Mounting
- Use a screwdriver to insert the wall anchors. Rotate the anchors clockwise while
pushing them gently into the wall. They have threads that are designed to engage
the dry wall as they are turned. Continue to rotate them until each flange touches
the dry wall surface.
- Insert the metal screws into the installed wall anchors, turning the screws
clockwise, leaving approximately ½” between the back of the screw head and the
wall.
- Align the wall bracket over the screw heads and slide the bracket down until the
slots fully engage the screw heads. Tighten or loosen screws as needed to fit the
wall bracket snugly against the wall.
Stud Mounting
With a screwdriver, insert the metal screws directly into the studs clockwise until tight
(you may wish to predrill a hole into the stud using an appropriate drill bit and power
drill).
Align the wall bracket over screw heads so that the slots provided on the back of the
bracket engage with the screw heads. Gently press the bracket down until firmly
engaged.