Filter
Top Products
19
PRO MIXER DX1000
Fig. 10.3: Insert send/return plug
11. CROSSFADER ADJUSTMENT
On the main motherboard you can find two potentiometers, which you can adjust with a little screwdriver.
These potentiometers are identified as OVERLAP and SLOPE. You can unscrew the bottom of your mixer to
reach the main motherboard.
+ Please be aware that the BEHRINGER warranty becomes discretionary when you start disas-
sembling your DX1000! Don’t even think of it, if you make much of your warranty privileges.
Sorry, but we have to mention this.
11.1 Overlap
With the OVERLAP potentiometer (VR43) you can adjust the increase or decrease in dB, which is conducted
when the crossfader is located in the middle position. Ex works this value is adjusted at -3 dB and should not
be modified. This guarantees a constant volume across the entire fader path.
11.2 Slope
With the SLOPE potentiometer (VR44) you can adjust the fade over process of the both channels. Dependent
on the setting of the SLOPE potentiometer there are the following volume curves:
11.CROSSFADER ADJUSTMENT