Filter
Top Products
• Loosen the 3 screws of the lower door hinges using a screwdriver.
(Do not remove completely)
• If the freezer compartment door is higher than the fridge compartment door, bring
them to the same level by turning the elevation screw on the fridge compartment side
in the direction of arrow using a M6 allen key as illustrated below:
• If the freezer compartment door is lower than the fridge compartment door, bring
them to the same level by turning the elevation screw on the freezer compartment side
in the direction of arrow using a M6 allen key in the similar way as explain above on
the opposite side.
After doing the above adjustments, the doors should be level. If the doors do not close
properly, this might adversely affect the operation and efficiency of the refrigerator.
7
STARTING
Final Check
Before you start using the fridge/freezer check that:
1. The feet have been adjusted so that the product is level.
2. The interior is dry and air can circulate freely at the rear of the cabinet.
3. Clean the interior as recommended under "CLEANING AND CARE."
4. Insert the plug into the wall socket and switch on the electricity supply.
• When the door is open the fridge interior light will come on.
5. You will hear a noise as the compressor starts up. The liquid and gases
sealed within the refrigeration system may also give rise to noise, whether the
compressor is running or not which is quite normal.
“Due to operation of the fan inside the frost free freezer compartment,
overall noise level is slightly higher in comparison to non-frost free appliances.
This is quite normal and is not a fault.”
6. Front edges of the cabinet may feel warm. This is normal. These areas are
designed to be warm to avoid condensation.
7. "Do not load the appliance immediately it is switched on. Wait until the
correct storage temperature has been reached. (See page 20)
8. When the freezer reaches the desired temperature the freezer fan will stop.
When the freezer fan is on, the noise will be louder when the freezer door is
opened.
9. Avoid spillage of food particularly small items like rice, peas, beans
through the fan guard and air flow vents as they may cause the cooling system
to block and therefore operate less efficiently.
10. The factory set temperature is +4°C for fridge compartment and -18°C for
freezer compartment.
11. The compressor will start running approximately 5 minutes after the
refrigerator is plugged in to protect the electronic components of your appliance.
After start up of the compressor, compartment temperatures will reach the set
temperatures in 24 hours depending on the ambient temperature and load in
your refrigerator.
12. Pay attention to the following points during the first 24 hours of the operation:
- Do not open the doors frequently.
- Do not overload your refrigerator.
- Do not put hot food.
6
allen key