Beko BK 9550 NF Refrigerator User Manual


 
2
Electrical requirements
Before inserting the plug into the wall socket
make sure that the voltage and the frequency
shown in the rating plate inside the appliance
corresponds to your electricity supply.
• Take care to ensure that the plug remains
readily accessible. Do not use multiple adapter
bar or extension cable.
Warning! This appliance must be grounded.
Repairs to electrical equipment should only
be performed by a qualified technician.
Incorrect repairs carried out by an unqualified
person carry risks that may have critical
consequences for the user of the appliance.
Transportation instructions
1. The appliance should be transported only
in upright position. The packing as supplied
must be intact during transportation.
2. If during the course of transport the
appliance, has been positioned horizontally,
it must not be operated for at least 4 hours, to
allow the system to settle.
3. Failure to comply with the above instructions
could result in damage to the appliance, for
which the manufacturer will not be held liable
for.
4. The appliance must be protected against
rain, moisture and other atmospheric
influences.
Important!
Do not attempt to sit or stand on top of your
appliance as it is not designed for such use.
You could injure yourself or damage the
appliance.
Make sure that the mains cable is not caught
under the appliance during and
after moving, as this could damage the cable.
Do not allow children to play with the
appliance or tamper with the controls.
Installation instructions
1. Do not keep your appliance in a room where
the temperature is likely to fall below 10
degrees C at night and/or especially in winter,
as it is designed to operate in ambient
temperatures between +10 and +43 degrees
C. At lower temperatures the appliance may
not operate, resulting in a reduction in the
storage life of the food.
2. Do not place the appliance near cookers or
radiators or in direct sunlight, as this will cause
extra strain on the appliance's functions. If
installed next to a source of heat or a freezer,
maintain the following minimum side
clearances:
From Cookers 30 mm
From Radiators 300 mm
From Freezers 25 mm
3. Make sure that sufficient room is provided
around the appliance to ensure free air
circulation.
• Fit the bottom airing lid given in your appliance
as shown in the diagram to the pins facing
one another on the feet at the bottom of the
door. Make sure claws and pins to hold each
other for the pins-claws connection (Fig. 4).
4. The appliance should be positioned on a
smooth surface. The two front feet can be
adjusted as required. To ensure that your
appliance is standing upright adjust the two
front feet by turning clockwise or counter
clockwise, until firm contact is secured with
the floor. Correct adjustment of feet prevents
excessive vibration and noise.
5. Refer to "Cleaning and Care" section to
prepare your appliance for use.
Instructions for useGB