Filter
Top Products
7 / 11 ENHood / User Manual
3.1 Drilling the Support surface and
Fitting the Hood
Hood Type 52 70
L1 497 677
Make a rectangular opening on the base of the
hanging unit, leaving a minimum of 13 mm from
the outer edges.
Snap-On Fitting
For hoods with snap-on side supports only, set
up for a support panel thickness of between 15
mmand 30 mm.
• Insert the hood until the side supports snap into
place.
• Lock in position by tightening the screws Vf
from underneath the hood.
3 Installation
Screw Fitting
For hoods without snap-on side supports only.
• Fix the hood to the hanging unit using the
screws 12f (3.5x16 self-threading) provided.
3.2 Connection
3.2.1 Ducted Version Air Exhaust
System
When installing the ducted version, connect the
hood to the chimney using either a flexible or rigid
pipe ø 120 or 150 mm, the choice of which is left
to the installer.
• To install a ø 120 mm air exhaust connection
insert the reducer flange 9 on the hood body
outlet.
• Fix the pipe in position using sufficient pipe
clamps (not supplied).
• Remove any activated charcoal filters.