Filter
Top Products
8
switching on for the first time
Ensure all packaging have been removed.
Ensure the appliance is kept for at least 4 hours in upright position.
Ensure the feet have been adjusted for levelling.
Ensure the interior is dry and air can circulate freely at the rear.
Ensure the interior is clean as recommended under ‘Care &
cleaning’
Insert the plug in to the wall socket and switch on the electricity
supply.
The blue mains on ‘power’ light on the door trim will be on when
the appliance is connected to the mains.
When the fridge door is open, the interior light in the fridge
compartment will come on.
You may hear some noise as the compressor and the freezer
fan start up. The liquid and gases may also give rise to noise,
whether the compressor is running or not, which is quite
normal.
“Due to operation of the fan inside the frost free
freezer compartment, overall noise level is slightly
higher in comparison to non-frost free appliances.
This is quite normal and is not a fault.”
Set the thermostat knob half way between Setting 1 and Setting 5.
Do not load with food immediately. Wait until the
correct storage temperature has been reached. We
recommend that you check the temperature with an accurate
thermometer (see section Temperature Control and Adjustment).
When the freezer reaches the desired temperature the freezer
fan will stop. When the freezer fan is on, the noise will be
louder when the freezer door is opened.
The front edges of the cabinet may feel warm. This is normal.
These areas are designed to be warm to avoid condensation.
Avoid spillage of food particularly small items like
rice, peas, beans through the fan guard as they may
cause the cooling system to block and therefore
operate less efficiently.
"[FOR CDA752F model only] Before you use the water dispenser for
the first time, clean the water tank interior with clean warm water."
1
2
3
4
5
6
•
•
•
7
8
9
•
10
11
Before you switch on the appliance check: