Beko CDA752F Refrigerator User Manual


 
transportation
5
The appliance should be transported only in a vertical upright
position. The packing as supplied must be intact during transportation.
If during the course of transport the appliance has to be
transported horizontally, the product must only be laid on its
right hand side (when facing the door front) and it must not be
operated for at least 4 hours to allow the system to settle after
the appliance is brought back to upright position.
Failure to comply with the instructions could result in damage
occurring to the appliance. The manufacturer will not be held
responsible if these instructions are disregarded.
The appliance must be protected against rain, moisture and
other atmospheric influences.
When positioning your appliance take care not to damage your
flooring, pipes, wall coverings etc. Do not move the appliance by
pulling by the door or handle.
Empty any water in the drain tray and Water Dispenser tank before
moving. See section ‘Defrosting’ and ‘Care & cleaning’ for further
information.
Make sure that the defrost water pipe at the back of the product
is fixed to the plastic evaporating pan on the top of the compressor,
to avoid defrost water spillage on the floor.
Important Care must be taken when carrying the appliance
to avoid touching the bottom of the condenser metal
support/pipework at the back of the appliance as you might injure
your fingers and hands or damage your product.
Important Make sure that mains cable is not caught under the
appliance during and after carrying/moving the appliance, to avoid
the mains cable becoming cut or damaged.
Do not attempt to sit or stand on top of your appliance. You
could injure yourself and damage the appliance.
BEKO plc declines to accept any liability should the instructions not
be followed.