Filter
Top Products
EN
9
REPLACING THE INTERIOR LIGHT
BULB
Should the light fail to work switch
off at the socket outlet and pull out the
mains plug.
Use a cross headed screw driver to
remove the light diffuser cover.
Then ensure the bulb is screwed
in until it is secure in the bulb holder.
Replace the plug and switch on.
If the bulb functions, reassemble by
reversing the above procedure, ensure
the top cover is in place.
If the light still fails to work obtain a
replacement screw cap type 15 Watt
(Max) bulb from your local electrical
store and then fit it as follows.
1. Switch off at the socket outlet and
pull out the mains plug. You may find
it useful to remove shelves for easy
access.
2. Remove the light diffuser cover
screw. Use cross-headed screw driver.
3. Pull off the light diffuser cover and
remove the light bulb.
4. Replace the burnt-out light bulb.
5. Reassemble reversing the sequence
and operations. First ensure the top of
the cover is in place.
6. Carefully dispose of the burnt-out
light bulb immediately.
“Replacement light bulb can easily be
obtained from a good local electrical or
DIY store.”