Filter
Top Products
EN
11
11. Reposition plugs and hinge
pin bushings on top of doors on the
opposite side of both doors. Use small
flat- h e a d e d
screwdrivers to remove plugs and
bushings. Take care not to mark doors.
(9)
12. Reposition left hand side feet
on the opposite side.(10)
13. Unscrew and remove the
upper door middle hinge pin bushing/
door stopper using a cross-headed
screwdriver.
Important: This part cannot be used
on the opposite side; left hand side
middle hinge pin
bushing/door stopper part is supplied
in the plastic bag.(11)
14. Re-fit the upper hinge on
the left hand side using flat-headed
screwdriver.(12)
15. Fit upper door left hand side
middle hinge pin bushing/door stopper
supplied in the plastic bag using
cross-headed screwdriver.(13)
16. Reposition three small plastic
plugs on the left hand side, which are
covering middle hinge holes, on the
opposite side to cover
holes left empty.(14)
17. Locate and re-fit upper door to
upper hinge and hold the door firmly.
(15)
18. Locate the middle hinge pin to
middle hinge pin bushing of upper door
on the left hand side and re-fit the
middle hinge.(16)
19. Reposition the two screws
fitted to lower hinge holes on the left
hand side at the bottom of the cabinet
on the opposite
side.(17)
20. Unscrew and reposition the
hinge housing and steel pant on
the right hand side at the bottom
of the door on the
opposite side. (18)
21. Locate and re-fit lower door
to middle hinge pin and then re-fit the
lower hinge on the left hand side.(19),
(20)
22. Carefully stand the appliance
upright and adjust the two front feet if
necessary.
23. Check that doors open and
close easily, they are aligned correctly
and that there are no gaps allowing
air into the cabinet. If
there are gaps between the door seal
and the cabinet, adjust the door seal by
gently pulling away
from the door using fingers.
24. Check that all the hinge screws
are tightened. Avoid over tightening the
screws.
25. Put all items, fittings back in
the appliance.
26. Fit upper door top trim plastic
hinge cover. Upper door top trim hinge
cover is supplied in the plastic bag.(21)
27. Wait for at least 4 hours to allow
the system to settle before switching
on.
28. Once the correct storage
temperatures have been reached in the
appliance, put back all the food.