Beko DIS 5831 Dishwasher User Manual


 
11
GB
1013
Filling the Rinse Aid
Dispenser
Rinse aids allow washing water to
rinse off more cleanly and prevent
watermarks or streaks on the dishes.
Only use rinse aid designed for use in
dishwashers.
If you use “2 in 1” or “3 in 1“
detergents / tablets, you do not need
an additional rinse aid.
Open the rinse aid dispenser by
pressing the locking lever (B)
Carefully pour in rinse aid to the MAX
mark. Close the lid until it clicks (3).
Carefully wipe off spilled rinse aid.
Excessive rinse aid causes excessive
foam formation, which may hinder
cleaning.
Set the dose of rinse aid
The dose of rinse aid to be used can
be set by means of the dispenser
regulator (between levels 1 and 6) (4).
Your appliance is pre-set at the factory
to level 3.
Only change the setting if the following
applies after washing:
• Watermarks are visible on the
dishes: Set dosage higher
• Streaks are visible on the dishes:
Set dosage lower
Filling the Detergent
Dispenser
Only use detergents formulated for
use in dishwashers.
Do not put solvents into the
washing compartment; there is the risk
of explosion!
Open the detergent container by
pushing the locking lever to the right
(A).
The lines on the inside of the detergent
container will help you measure the
correct amount of detergent.