Filter
Top Products
16
GB
service wash at the highest temperature
possible every 3 - 4 months with the
dishwasher empty and without using
detergent. It is not recommended to carry
it out with auto programme.
Rinse aid
Use only rinse aid intended for household
dishwashers.
Filling
detergent
dispenser
If the dishwasher
is considerably full
and the dishes are
relatively dirty, fill the
main container (A)
up to 25cm³ level.
If the dishwasher is not quite full and
the dishes are only slightly soiled, fill
the main container (A) only up to 15cm³
level.
If your dishes are kept unwashed for
a long time and the food particles are
stuck on the dishes also fill the small
container (B) up to 5cm³. Depending
on the degree of soiling and the
water hardness in your area it may be
necessary to add more detergent.
Powder and gel detergents are poured
into the dispenser.
If you are using tablet detergent read the
manufacturer’s recommendations on the
packaging in order to determine where
the tablets should be placed inside the
dishwasher (detergent dispenser, cutlery
basket, etc.)
After you put in the detergent, shut the
container lid (D) and ensure you hear
the clicking sound.
During the wash programme the
detergent will dispense automatically
and the lid (D) will remain open when the
programme finishes.
Do not use detergent when using the
pre-wash programme.
Detergent residues
Regular use of low temperature washes
and/or short duration programmes can
lead to undissolved detergent residue
build up. We recommend to carry out a
The rinse aid is specially formulated
to be used in the dishwashers for the
prevention of watermarks and scale on
dishes and to increase the efficiency
of the washing and drying processes.
Therefore, make sure that
there is adequate amount of rinse aid in
the rinse aid dispenser of your machine.
You can adjust the amount of rinse aid
used during the wash programme by
turning the rinse aid dispenser regulator
(C).
The dispenser regulator (C) may be set
between levels 1 and 6 (6 being the
maximum amount of rinse aid usage).
Your machine is pre-set at the factory to
level 4.
According to the finish and drying results
obtained, adjust the dose of rinse aid by
means of the six position
selector. (Position 1: minimum dose,
Position 6: maximum dose.) Gradually
increase the dose if there are drops of