Filter
Top Products
24
GB
To add a function to the programme:
1. Select the programme by pressing
programme selection button.
2. Press the button of the function
that you want to enable and check
to see a indicator for the relevant
function on the display.
3. You can start the programme by
pressing the Start / Pause / Cancel
button.
Programme Steps Follow-up
You can follow up the step while
current programme is running from the
Programme Steps follow up indicator
a Washing Step Indicator
b Drying Step Indicator
c End of Programme Indicator
The display shows the steps for
washing and drying, respectively, while
the selected programme is running.
Only the End of Programme indicator
lights up when the programme is over.
Remaining Time Indicator displays
“0:00”.
Cancelling a Programme
Press Start / Pause / Cancel button for
three seconds to cancel a programme
that is already running. Release the
button when symbol start flashing
in the display. For a couple of minutes
the machine will fulfill the necessary
operations required for cancellation.
Remaining time indicator displays
“0:00”. You may select and operate
a new programme following the
programme cancellation process.
There might be residues of detergent
or rinse aid left in the machine and/or
on the pieces being washed depending
on the step the previous programme
was in at the time of such cancellation.
Changing a Programme
If you want to change running
programme, first of all press Start /
Pause / Cancel button to switch your
machine into pause mode. Second,
switch to the desired programme by
pressing Programme Selection button.
Third, Start the new programme
by pressing Start / Pause / Cancel
button again. Your new selection will
resume operation from the step in the
previous programme (For example, if
the previous programme was in rinsing
step, the new one will also start from
the rinsing step). If you want to run
the newly selected programme from
the beginning, you have to apply the
programme cancellation process first
and then select a new programme.
Programming the Time Delay
You can delay the start of the selected
programme until 9 hours. Time Delay
can not be set after the programme
starts. The selected programme must
not be started in order to be able to set
the delay time.
Time Delay indicator sand glass will
start flashing when the Time Delay
button is pressed. You can set the
desired time by pressing the Time
Delay button. Press the Start / Pause
/ Cancel button after setting the time.
The Time Delay indicator sand
glass and play icon will remain lit on
the display during the delayed start
countdown and the delay time indicator
will display the remaining time.
Programme will start automatically
when the countdown is over.
You can use the Time Delay function
if you are utilizing the economic
electricity tariff.