Filter
Top Products
26
GB
If you switch off the machine with
“On/Off” button when the status is
“OFF”, then the rinse aid indicator
will never come on.
Starting Your Machine
Plug the mains plug into the wall •
socket.
Open the tap.•
Open the door. •
Place the dishes.•
Check if the upper and lower •
impellers rotate freely.
Put sufficient amount of detergent •
in the detergent dispenser and
close its lid.
Press On/Off button.•
Check if the salt and rinse aid •
warning indicators light and add
salt and/or rinse aid if needed.
Determine your washing •
programme with the aid of the
Programme Data and Table of
Average Consumption Values.
You can select the determined •
washing programme by pressing
programme selection button.
You can see the programme time •
in the Remaining Time Indicator.
If necessary, you can change your •
washing programme as you prefer
by means of the Add Function
Buttons.
Start the programme by pressing •
the Start / Pause / Cancel button.
WARNING:
Pay attention not to open the door of
the machine when it is running. Stop
the machine by pressing Start / Pause
/ Cancel button if you have to open
the door. Then, open the door of your
machine. There may be a rush of
vapor when you open the door of your
machine; be careful. Close the door
and press Start/Pause/Cancel button
again. Programme will resume running.
End of Programme indicator will •
light up.
Turn off your machine by pressing •
On / Off button.
Close the tap.•
Unplug the mains plug from the •
wall socket.
Leave your dishes in the machine •
for about 15 minutes after they
are washed in order to have them
cooled down. Your dishes will dry
in a shorter time if you leave the
door of your machine ajar during
this period. This will increase
the drying effectiveness of your
machine.