Filter
Top Products
25 / 34 EN
Refrigerator / User Guide
Using the product
5.6. Taking ice / water
(Optional)
To take water ( ) / ice cube ( ) / fragmented
ice ( ), use the display to select the respective
option. Take water/ice by pushing the trigger
on the water fountain forward. When switching
between ice cube ( ) / fragmented ice ( )
options, the previous ice type may be discharged a
few more times.
• You must wait approximately 12 hours before
taking ice from the ice / water fountain for the
first time. The fountain may not discharge ice if
there is insufficient ice in the ice box.
• The 30 pieces of ice cubes (3-4 Litres) taken
after first operating should not be used.
• In case of power blackout or temporary
malfunction, the ice may partly melt and re-
freeze. This will cause the ice pieces to merge
with each other. In case of extended power
blackouts or malfunction, the ice may melt
and leak out. If you experience this problem,
remove the ice in the ice box and clean the
box.
A
WARNING: The product’s water system
should be connected to cold water line
only. Do not connect to hot water line.
• The product may not discharge water during
first operation. This is caused by the air in
the system. The air in the system must be
discharged. To do this, push the water fountain
trigger for 1-2 minutes until the fountain
discharges water. The initial water flow may be
irregular. The water will flow normally once the
air in the system is discharged.
• The water may be cloudy during first use of
the filter; do not consume the first 10 glasses
of water.
• You must wait approximately 12 hours to get
cold water after first installation.
• The product’s water system is designed
for clean water only. Do not use any other
beverages.
• It is recommended to disconnect the water
supply if the product will not be used for long
periods during vacation etc.
• If the water fountain is not used for a long
time, the first 1-2 glasses of water received
may be warm.
5.7. Drip tray
(optional)
The water dripping from the water fountain
accumulates on the drip tray; no water drainage is
available. Pull the drip tray out or push on the edges
to remove the tray. You may then discharge the water
inside the drip tray.