Filter
Top Products
STARTING
Final Check
Before you start using the fridge/freezer check that:
1. The feet have been adjusted so that the product is level.
2. The interior is dry and air can circulate freely at the rear of the cabinet.
3. Clean the interior as recommended under "CLEANING AND CARE."
4. Insert the plug into the wall socket and switch on the electricity supply.
• When the door is open the respective interior light will come on.
5. You will hear noise as the compressor starts up. The liquid and gases sealed
within the refrigeration system may also give rise to noise, whether the
compressor is running or not which is quite normal.
“Due to the operation of fans inside the appliance, overall noise level is
slightly higher in comparison to non-frost free appliances. This is quite normal
and is not a fault.”
6. Front edges of the cabinet may feel warm. This is normal. These areas are
designed to be warm to avoid condensation.
7. "Do not load the appliance immediately it is switched on. Wait until the
correct storage temperature has been reached.
8. When the compartments reach the desired temperatures fans will stop. When
the freezer fan is on, the noise will be louder when the freezer door is opened.
9. Avoid spillage of food particularly small items like rice, peas, beans through
the fan guard and air flow vents as they may cause the cooling system to
block and therefore operate less efficiently.
10. The factory set temperature is +4°C for fridge compartment and -18°C for
freezer compartment.
11. The compressor will start running approximately 5 minutes after the
refrigerator is plugged in to protect the electronic components of your appliance.
After start up of the compressor, compartment temperatures will reach the set
temperatures in 24 hours depending on the ambient temperature and load in
your refrigerator.
12. Pay attention to the following points during the first 24 hours of the operation:
- Do not open the doors frequently.
- Do not overload your refrigerator.
- Do not put hot food.
6