Filter
Top Products
EN
5
3 Radio Interference
Microwave oven may cause interference to
your radio, TV, or similar equipment. When
interference occurs, it may be eliminated
or reduced by the following procedures.
a) Clean the door and sealing surface of
the oven.
b) Place the radio, TV, etc. as far away
from your microwave oven as possible.
c) Use a properly installed antenna for
your radio, TV, etc. to get a strong signal
reception.
4 Installation
1. Make sure all the packing materials
are removed from the inside of the door.
2. Inspect the oven after unpacking for
any visual damage such as:
- Misaligned Door
- Damaged Door
- Dents or Holes in Door Window and
Screen
-Dents in Cavity
- If any of the above are visible, DO NOT
use the oven.
3. This Microwave Oven weighs 19 kg
and must be placed on a horizontal
surface strong enough to support this
weight.
4. The oven must be placed away from
high temperature and steam.
5. DO NOT place anything on top of the
oven.
6. DO NOT remove the turn -table drive
shaft.
7. As with any appliance, close supervi-
sion is necessary when used by children.
WARNING - THIS APPLIANCE MUST
BE EARTHED.
1. The plug socket should be within easy
reach of the power cord
2. This oven requires 1.5 KVA for its input
consultation with service engineer is sug-
gested when installing the oven.
CAUTION: This oven is protected inter-
nally by ac 250V, 10 Amp Fuse.
IMPORTANT
The wires in this mains lead are coloured
in accordance with the following code:
Green-and-yellow : Earth
Blue : Neutral
Brown : Live
As the colours of the wires in the mains
leads of the appliance may not corre-
spond with the coloured markings identi-
fying the terminals in your plug, proceed
as follows:
The wire which is coloured greenand-
yellow must be connected to the terminal
in the plug which is marked with the letter
E or by the earth symbol coloured green
of green-and-yellow.
The wire which is coloured blue must be
connected to the terminal which is
marked with the letter N or coloured
black. The wire which is coloured brown
must be connected to the terminal which
is marked with the letter L or coloured
red.