Filter
Top Products
IMPORTANT
INSTALLATION INSTRUCTIONS
1. The space in the room where the appliance is installed must not be smaller
than 10 cubic metres.
2. If possible avoid placing the appliance near cookers, radiators or in direct
sunlight as this will cause the compressor to run for long periods. If installed
next to a source of heat or refrigerator, maintain the following minimum side
clearances:
From Cookers 2" (50 mm)
From Radiators 12" (300 mm)
From Refrigerators or Larder Fridge 1" (25 mm)
3. Make sure that sufficient room is provided around the appliance to ensure free
air circulation. Allow a minimum of 60 mm (2.4 inches) between the top of the
fridge and the ceiling or the underside of a wall cupboard.
4. Fit the two plastic wall spacers supplied with the appliance rotating 1/4 turn
to the condenser at the back of the appliance (See diagram).
5. The appliance should be located on a smooth surface.
The two front feet can be adjusted as required.
To ensure that,your appliance is standing
upright adjust the two front feet by turning
clockwise or anti-clockwise, until the product
is in firm contact with the floor. Correct
adjustment of feet avoids excessive
vibration and noise.
6. Refer to "Cleaning and Care" section to
prepare your appliance for use.
5
A special receptacle is supplied to store the
mains plug during transit.
The receptacle is fixed at the back of the
cabinet, on the right hand side of the
compressor. (See diagram) Gently remove
the plug from the receptacle. Never pull
the mains cord, you may damage the
appliance. In the case of transportation,
ensure you locate the plug in the receptacle
provided to avoid transit damage.
7.
Electronic card
(covered by plastic cover)