Filter
Top Products
26
Connect to the gas supply
The inlet to the cooker is
1
⁄2” BSP
internal situated at the rear right corner.
Fit the bayonet connection. This should
be located so as to ensure that the
flexible connector hose does not kink.
IMPORTANT : Under no circum-
stances should the flexible connector be
allowed to come into contact with the
vertical oven flue tubes on the rear of
the appliance.
Use a 900mm - 1125mm length of
flexible connector.
Ensure that all pipe work is of the correct
rating for both size and temperature.
Natural Gas - Flexible connections
should comply with BS 669. Parts of
the appliance likely to come into
contact with a flexible connector have
a temperature rise of less than 70˚C.
After installation, make sure all
connections are gas sound.
Commissioning
Burner aeration
All burners have fixed aeration and no
adjustment is possible.
Pressure setting
G20 Natural Gas @ 20 mbar
Pressure test point
Use the oven injector.
Grill - Open the top oven / grill door.
Push in and turn the top oven / grill
control knob clockwise to the ‘
FULL ON’
position.
Hob burner - Turn the control knob
to the FULL ON position, wait a second
before pressing the ignition switch or
holding a lighted match or taper to the
burner. Hold the control knob in for 15
seconds. Do not hold the control knob
in for longer that 15 seconds. If the
burner fails to light within this time,
release the control knob and wait one
minute before attempting further igni-
tion.
Ovens - Open the oven door. Turn
the control to the FULL ON position and
press the ignition switch, or hold a
lighted match or taper to the burner.
Hold the control knob in for 15 sec-
onds. Do not hold the control knob in
for longer that 15 seconds. If the burn-
er fails to light within this time, release
the control knob and wait one minute
before attempting further ignition.
Before leaving the installation
1. Place all the loose parts of the
cooker into position.
2. Show the customer how to operate
the cooker and give them this
handbook. Thank you.
Installation Instructions