Filter
Top Products
Burner Ignition
Push in and turn the selected control
knob anticlockwise to the ‘full on’ position
and press the ignition switch, or hold
a lighted match or taper to the burner,
until the burner lights.Hold the control
knob in for 15 seconds. Do not hold
the control knob in for longer that 15
seconds. If the burner fails to light
within this time, release the control
knob and wait one minute before
attempting further ignition.
Turn the control knob to the required
setting.
Adjust the burner flame so that it does
not extend over the pan base.
To turn off, push in the control knob
and turn clockwise until the dot on the
control knob is below the dot on the
facia panel.
To simmer - all burners
The simmer position is marked by the
small flame symbol.
Turn the selected control knob past the
large flame symbol (FULL ON) to the
small flame symbol.
You may hear a slight popping noise
when the hob burners are operating
and this is quite normal, but if anything
about the cooker appears unusual,
such as change in flame appearance,
or the operation of controls - seek
expert advice.
The control knob can be set at any
position between the small flame and
large flame symbols, allowing for
greater control, and flexibility, while
cooking.
6
Using the Hob