Filter
Top Products
– 8 –
BOWL GUARD / WIRE CAGE
Bowl Guard/Wire cage must be in position and closed in order to mix. If Bowl Guard/wire cage is opened
during the mixing, mixer will stop.
REMOVE BOWL GUARD / WIRE CAGE
Lower the bowl support and remove agitator before removing bowl guard/wire cage. Hold wire cage with
both hands and pull downward gently to release from retainer (Fig. 5).
INSTALL BOWL GUARD / WIRE CAGE
Hold Bowl Guard/wire cage with both hands and gently push upward until bowl guard/wire cage is latched
on the retainer and can be rotated freely (Fig. 5).
CLEANING
Disconnect the electrical power to the mixer before beginning any cleaning
procedures.
The mixer should be thoroughly cleaned daily.
Bowls and agitators should be removed from the mixer and cleaned in a sink.
DO NOT use a hose to clean the mixer — it should be washed with a clean damp cloth.
Clean the bowl guard/wire cage by wiping with a cloth or sponge and warm soapy water.
DO NOT place agitators, attachments or mixer components in a dishwasher for cleaning.
Fig. 5
FMS60 Owner/Operator Manual