Filter
Top Products
5
SPECIFICATION
̅ The voltage and wattage are given on the rating plate found on the device.
̅ Minimum filling capacity: 0.3 l
̅ Maximum filling capacity: 1.0 l
BEFORE USING FOR THE FIRST TIME
̅ Read the operating instructions carefully and keep them handy.
̅ Remove packaging and any stick-on labels on or inside the device.
̅ Check that the voltage given on the base of the device agrees with that of the mains supply.
̅ Thoroughly rinse all parts of the brewing system and the glass carafe.
- Before using the tea and coffee maker for the first time please carry out the following:
- Remove the brewing chamber.
̅ Fill the glass carafe up to the maximum mark with water and add a teaspoonful of lemon juice (or lemon concentrate).
If no lemon is available, place a teabag (or a teaspoonful of tea leaves directly into the water.
̅ Put the lid in place.
̅ Switch on and then wait for the automatic switch-off.
̅ Rinse the device with water.
Your tea and coffeemaker is now ready for use.
Please read carefully through all advice and instructions.
̅ Warning: Do not put any sugar in the tea and coffee maker. Do not heat milk in the tea and coffee maker.
OPERATION
1 Take the carafe off the base.
2 Take the lid off the glass carafe and remove the brewing system.
3 The brewing system can be placed down on a level surface.
4 Fill the glass carafe with the required amount of water. This can be between a minimum of 0.3 l and
a maximum of 1.0 l of water. The respective filling marks can be found on the outside of the carafe.
Warning: So as to avoid the risk of burns and electric shock,
please ensure that no water overflows from the carafe.
5 To open, turn the lid anti-clockwise whilst holding the brewing chamber (see Fig. aaa).
6 Place the required amount of coffee, tea or teabags into the brewing chamber. Do not fill the coffee or tea
above the marks inside the brewing chamber. Refer to the instructions in the section ‘Making tea and coffee’.
7 Put the lid back on and lock it in place by turning it to the right whilst holding the brewing chamber.
8 Place the brewing chamber back in the carafe. Make sure that the water outlet pipe is securely seated in the
heating element opening.
Switching on the device
WARNING: Do not place the device on the main unit until you have filled it with water.
a. Place the carafe on the base and push the plug into the mains socket.
b. Switch on the device by pressing switch "1”.
c. The red indicator light comes on and the brewing process begins.