Filter
Top Products
Use
Warning! Always place the appliance on a
flat, clean and non-slip surface before
operating it.
Warning! Always allow the product and
contents to cool before opening the lid /
re-filling.
Warning! Always check the water level
while using the appliance. Never use the
appliance without sufficient water.
Warning! Steam may escape from the
spout.
Warning! This Kettle must only be used
with the Kettle base provided.
• Place the kettle base (7) on a suitable
surface.
• Take the kettle to a water outlet. Press
the lid button (9) to open the lid (2).
• Fill the kettle with cold water to the
desired level.
• To prevent dry-boiling fill to at least 250
ml (one cup).
• Do not fill the kettle beyond the
maximum fill mark (4). If the kettle is
overfilled, boiling water may be ejected
from the spout.
• Close the lid (2) and make sure it snaps
into place.
• Place the kettle on the kettle base (7).
• Insert the plug into a suitable electrical
outlet and push the switch (1) to the on
position (I).
• The power on indicator (6) will light.
• The water will start boiling, making a
rumbling noise. Do not open the lid
when the water is boiling.
• As soon as the water has boiled, the
appliance will switch off and the power
on indicator (6) will go out.
• Always ensure the Kettle has turned off
before lifting it from the Kettle base.
• To switch the appliance off during boiling,
push the On / Off switch (1) the off
position (O).
• If you do not want to use the boiled
water immediately, the kettle may be left
on the base. If you want to bring the
water back to boil after a while, push the
on / off switch (1) to on again.
Pouring boiled water
• Make sure the appliance is switched off.
• Take the kettle off the base.
• To avoid scalding, tilt the kettle slowly to
pour the boiled water.
• After pouring, place the kettle back on
the base and remove the plug from the
socket.
Cleaning and maintenance
Before cleaning and maintenance, remove
the plug from the socket and allow the
appliance to cool.
Warning! Before cleaning and maintenance,
switch the appliance off, remove the plug
from the socket and allow the appliance to
cool.
Warning! Do not immerse the appliance, the
base, the cord set or the plug in water or
any other liquid.
• Wipe the exterior with a damp cloth.
• Do not use scouring pads.
• If necessary, use a mild detergent to
remove spots.
• Do not use any abrasive or solvent based
cleaner.
• Do not immerse the appliance in water or
any other liquid.
English
-6-