Filter
Top Products
Présentation de votre lave-vaisselle
13
Présentation de votre lave-vaisselle
12
Press the “ON / OFF” button to
switch on the machine.
Refer to the Programmes table on
the following pages to determine
the best programme for the
amount of washing up and how
dirty it is.
The display shows the current time.
Press the button for the programme you desire; the illuminated light
shows the selected programme.
To change your selection, press another programme button.
The display shows the remaining time of the programme selected.
Press “Start” to activate the selected programme.
Setting the Time
Selecting a Washing Programme
Check that your power
cable is connected and
your water tap is open.
Time Setting:
When the machine is
first switched on, the
clock reads
and the colon flash-
es. To set the current
time, hold down the “Soak” button and press the “Delayed
Programme End” button to set the hour. Continue to hold down the
“Soak” button for a few seconds and press the “Delayed
Programme End” button again to set the minutes.
:
Loading the dishwasher
Check that the slides are both at the same height and that the basket is
level.
The upper basket
This basket is designed in particular to
take: glasses, cups, ramekins, small salad
bowls, bowls, saucers, etc.
You can also place cups, ladles, etc. on the
foldaway brackets as well as a cutlery basket.
Arrange stemmed glasses along the wire shelf.
Place glasses, cups and
bowls facing downwards.
The “Mezzanine” wire shelf enables you
to load cutlery of any size. You can place it
either in the upper or lower basket.
①①
②②
Adjusting to the HIGH POSITION
Gently lift the basket until you hear
the first “Click” on both sides.
Do not try to lift higher.
Adjusting to the LOW POSITION
Lift the basket at the back on both sides
(“Click”) and then gently lower it.
Depending on the model: when loading large plates into the lower
basket, you may have to adjust the height of the upper basket. This
can be done even when the basket is full.
To make loading
easier, move the
tray to position
➊
and then return it
to position
➋
.