Filter
Top Products
EN
12
Connecting of the water
hose to the cold water mains
line
(in some models)
If you will use the refrigerator by
connecting it to the cold water mains
line, you must install a standard 1/2”
valve connector to the cold water
installation of your home. If this valve
is not present or you are not sure,
consult a qualified plumber.
1.Separate the union from the tap
adaptor.
2.Install the tap adaptor to standard
1/2” valve connector.
3.After inserting the water hose to the
union, install it to the tap adaptor and
insert to the union to the tap adapter.
4.Tighten the union by hand.
WARNING: Secure the water hose
to suitable points by means of the
clips supplied to avoid any damage
or displacement or accidental
disconnection.
WARNING: After turning on the water
valve, make sure that there is no
leakage at both connection points of
the water hose. If there is a leakage,
turn off the valve immediately and
tighten all joints again using a spanner
or a pliers.
WARNING: Make sure that standard
1/2” valve connector is available and
completely turned off on your cold
water mains line.