Blomberg IWD 1006 XT Refrigerator User Manual


 
EN
18
C Water mains pressure must not be
over 8 bars.
C Pumps must be used in case the
supply water pressure drops below 1 bar
or if a jug is going to be used.
1. Separate the union from the tap
adaptor. (Figure A)
2. Install the tap adaptor to 1/2” valve
fitting as shown in the figure. (Figure B)
3. After inserting the water pipe to the
union, install it to the tap adaptor and
insert to the tap as shown in the figure.
(Figure C)
4. Tighten the union manually. In case of a
leak use a spanner or a pair of pliers to
tighten the union.
A Warning: Secure the water pipe
to suitable points by means of the
pipe clips supplied to avoid any
damage or displacement or accidental
disconnection.
A Warning: After turning on the water
valve, make sure that there is no leakage
at both connection points of the water
pipe. In case of a leak, turn off the valve
immediately and tighten all joints again
using a spanner or a pair of pliers.
A Warning: Make sure that standard
1/2" valve fitting fed by cold mains water
supply is available and is turned off fully.
Note -1: There is no need to use water
filter in case a jug is used.
Note -2: Pump must be used when jug will
be used.
Prior to first use of Ice/Water
Dispenser
C Water mains pressure must not be
below 1 bar.